Solid works, Inventor, Bambu, Fussion, Orca Slicer, ProgeCAD, AutomationDirect software too

I think that’s all I have on my laptop

I always look at the “gang signs” they make with total confusion. These ones are all different. I was even trying to see if they were spelling something.

The other post suggesting a general handyman is probably where I’d start too. But I’d also dive into the rabbit hole. Old TV setups had an optional motor for moving the antenna. Saves a lot of aggravation later.

Check for lighting strike dangers

https://www.otadtv.com/installation/

http://www.palcoelectronics.com/tower_installation.aspx